Wireless > wireless network site survey, Wireless network site survey, Wireless > wireless network site survey 10 – Cisco WET610N User Manual
Page 11
10
Advanced Configuration
Linksys WES610N/WET610N
Method #2
Use this method if your router requests the PIN number of the bridge
1. On the router’s Wi-Fi Protected Setup screen, enter the PIN number on
the bridge’s Wi-Fi Protected Setup screen Then click Register or the
appropriate button (It is also listed on the label on the bottom of the
bridge )
2. On the bridge’s Wi-Fi Protected Setup screen, click OK
3. After the bridge has been configured, click Close
The Wi-Fi Protected Setup screen displays the Link Status, Network Name (SSID),
and Security method
Wireless > Wireless Network Site Survey
Click the Wireless Network Site Survey tab to begin a site survey The Wireless
Network Site Survey screen lists the wireless networks detected by the bridge
Wireless Network Site Survey
Number of Wireless Networks
The number of wireless networks detected by
the bridge is displayed
Select
To connect to a wireless network, click Select Then click Connect
Wireless Network Name
The network name or SSID of the wireless network
is displayed
GHz
The radio band of the wireless network is displayed
Signal
The percentage of signal strength is displayed 100% is the strongest
signal strength possible; 0% is the weakest possible
Security
If the network supports Wi-Fi Protected Setup, the Wi-Fi Protected
Setup icon
is displayed The security method used by the wireless network
is displayed
Click Refresh to update the on-screen information
After you have selected a network, click Connect A new screen appears Follow
the instructions for the security method of your network
WPA
Network Name (SSID)
The name of the network you selected is automatically
displayed
Security Mode
WPA Personal is automatically displayed
Encryption
WPA supports the TKIP encryption method, with dynamic
encryption keys
Passphrase
Enter the key shared by the bridge and wireless router or access
point It must have 8-63 characters
Click Refresh to update the on-screen information
After you have entered the security settings, click Connect