Whirlpool 915 - Manual (Page 13)

USING THE DISPENSERS
Using the rinse agent dispenser
Keep the rinse agent dispenser filled with a
liquid rinse agent.
A rinse agent greatly
improves dish drying by heiping water
fiow off them during the iast rinse.
A rinse
agent also keeps water from forming
droplets and drying as spots or streaks.
A small amount of rinse agent automati­
cally releases into the rinse water during the
final rinse of each cycle.
For best drying
resuits, check dispenser periodicaiiy to
see if it needs filiing.
To check dispenser:
• Check center of fill indicator cap. Clear
means it needs filling.
OR
• Remove fill indicator cap. An “E” is visible
when dispenser is empty.
OR
Cap center clear
when empty
“E” visible
when empty
To fill dispenser:
The rinse agent dispenser holds 6 ounces.
Under normal conditions, this lasts about
3 months.
1. Open dishwasher door completely.
2. Remove fill indicator cap.
3. Add rinse agent. Fill to smallest opening
in lower part of dispenser only. Overfilling
may cause rinse agent to leak out. This
will not harm the dishwasher, but could
cause oversudsing.
4. Clean up any spilled rinse agent with a
damp cloth.
5. Replace fill indicator cap. Keep it closed
tightly.
NOTE: You do not have to wait until the
dispenser is empty before refilling, but do
not overfill it. Your dishwasher is designed
to use a liquid rinse agent. Do not use a
solid or bar-type rinse agent.
Do not fill past
smallest opening
Keep dispenser filled for best drying results
13