CHEVROLET 2011 Corvette - Manual (Page 187)

Black plate (65,1) Chevrolet Corvette Owner Manual - 2011
Instruments and Controls 5-65
Programming Universal Home
Remote — Rolling Code
For questions or help programming
the Universal Home Remote
System, call 1-866-572-2728 or
go to www.learcar2u.com.
Most garage door openers sold
after 1996 are Rolling Code units.
Programming a garage door opener
involves time-sensitive actions, so
read the entire procedure before
starting. Otherwise, the device will
time out and the procedure will have
to be repeated.
To program up to three devices:
1. Press START or put the vehicle
in accessory mode. See Ignition
Positions on page 9‑20 for
additional information.
Programming can only occur
when the vehicle is running or in
accessory mode.
2. From inside the vehicle,
press the two outside buttons
at the same time for one to
two seconds, and immediately
release them.
3. Locate in the garage, the
garage door opener receiver
(motor-head unit). Locate the
“Learn” or “Smart” button. It
can usually be found where
the hanging antenna wire is
attached to the motor-head unit
and may be a colored button.
Press this button. After pressing
this button, complete the
following steps in less than
30 seconds.