CHEVROLET 2012 Camaro - Manual (Page 31)

Black plate (5,1) Chevrolet Camaro Owner Manual (Include Mex) - 2012
Keys, Doors, and Windows 2-5
Battery Replacement
The battery is not rechargeable. To
replace the battery:
1. Extend the key blade and open
the battery cover on the back of
the transmitter by prying it with a
finger.
2. Remove the used battery by
pushing on the battery and
sliding it toward the key blade.
3. Insert the new battery, positive
side facing up. Push the battery
down until it is held in place.
Replace with a CR2032 or
equivalent battery.
4. Snap the battery cover back on
to the transmitter.
Remote Vehicle Start
Your vehicle may have this feature
which allows you to start the engine
from outside the vehicle.
/ (Remote Vehicle Start): This
button will be on the RKE
transmitter if you have remote start.
During a remote start the climate
control system will turn on with the
fan speed, air delivery mode, and
temperature settings that the system
was set to when the vehicle was
last turned off. If the fan is set to O
(Off), the climate control system will
not turn on.
Laws in some local communities
may restrict the use of remote
starters. For example, some laws
may require a person using remote
start to have the vehicle in view.
Check local regulations for any
requirements.
Other conditions can affect the
performance of the transmitter. See
Remote Keyless Entry (RKE)
System on page 2‑3.
Starting the Vehicle
To start the engine using the remote
start feature:
1. Aim the RKE transmitter at the
vehicle.
2. Press and release
Q
.
3. Immediately after completing
Step 2, press and hold / until
the turn signal lamps flash, or for
about two seconds if the vehicle
is not in view.
When the engine starts, the
parking lamps will turn on and
remain on as long as the engine
is running. The vehicle's doors
will be locked and the climate
control system may come on.
The engine will continue to run
for 10 minutes. Repeat the steps
for a 10-minute time extension.
Remote start can be extended
only once.
Insert the key and turn it to ON/RUN
before driving.