beautypg.com

8 driving and operating – CHEVROLET 2012 Corvette User Manual

Page 230

background image

Black plate (8,1)

Chevrolet Corvette Owner Manual - 2012

9-8

Driving and Operating

ZR1 and Z06 with Z07
Performance Package Brake
Burnish Procedure

Notice: These procedures are
specific to the ZR1 and Z06
Performance Package with
ceramic brake rotors. These
procedures should not be run on
other Corvette models as damage
may result.

Notice: The new vehicle break‐in
period should be completed
before performing the brake
burnish procedure or damage
may occur to the powertrain/
engine. See New Vehicle Break-In
on page 9‑18
.

When performed as instructed,
these procedures will not damage
the brakes. During the burnishing
procedure, the brake pads will
smoke and produce an odor.
The braking force and pedal travel
may increase. After the procedure is
complete, the brake pads may
appear white at the rotor contact.

Street High Performance Brake
Burnishing Procedure

Run this procedure in a safe
manner and in compliance with all
local and state ordinances/laws
regarding motor vehicle operation.
Run this procedure only on dry
pavement.

1. From a stop, accelerate as

rapidly as possible without
activating traction control to a
speed of 97 kph (60 mph).

2. Use enough pedal force to

completely stop the vehicle in
four to five seconds. If ABS
activates, braking is too hard.

3. Repeat Steps 1 and 2,

five times. This should take
about 10 minutes.

4. After completing the 50 stops,

cool the brakes by driving for
8 km (5 mi) at 97 kph (60 mph).

As with all high performance brake
systems, some amount of brake
squeal is normal.

Racing/Track Brake Burnish
Procedure

To prepare the ZR1 and Z06 with
Z07 Performance Package brake
system for track events and racing,
the Street High Performance Brake
Burnish as described previously
should be completed.

In addition to completing the Street
High Performance Brake Burnishing
Procedure, the following procedure
needs to be completed to make the
ZR1 and Z06 with Z07 Performance
Package brake system ready for
track events and racing.

This procedure should only be
run on a track and only on dry
pavement.