Champion Power Equipment 14560 - Manual (Page 20)

17
REV 14560-20130415
ENGLISH 14560
TROUblESHOOTING
For further technical support:
Technical Service
Mon – Fri 8:30 AM – 5:00 PM (PST/PDT)
Toll Free: 1-877-338-0999
[email protected]
Problem Cause Solution
Motor does not turn on Switch Assembly not connected
properly Insert Switch Assembly all the way into the connector.
Loose battery cable connections Tighten nuts on all cable connections.
Contactor malfunctioning Tap contactor to loosen contacts. Apply 12 volts to
coil terminals directly. A clicking indicates proper
activation.
Defective Switch Assembly Replace Switch Assembly.
Defective motor Check for voltage at armature port with Switch
pressed. If voltage is present, replace motor.
Water has entered motor Allow to drain and dry. Run in short bursts without
load until completely dry.
Motor runs but Cable
drum does not turn Clutch (Cam Ring) not engaged Move Cam Ring to the "In" position. If problem
persists, call a qualified service technician to check
and repair.
Motor runs slowly or
without normal power Insufficient current or voltage The battery is weak, recharge. Run winch with vehicle
motor running (Battery should have a strong charge)
Loose or corroded battery cable
connections. Clean, Tighten, or replace.
Motor overheating winch running time too long Allow winch to cool down periodically.
Motor runs in one
direction only Defective or stuck Contactor Tap Contactor to loosen contacts.
Repair or Replace contactor.
Defective Switch Assembly Replace Switch Assembly.