Champion Power Equipment 100133 - Manual (Page 28)

25
ENGLISH 100133
TROUBLESHOOTING
For further technical support:
Technical Service
Mon – Fri 8:30 AM – 5:00 PM (PST/PDT)
Toll Free: 1-877-338-0999
tech@championpowerequipment .com
Problem Cause Solution
Engine will not start No fuel Add fuel
Faulty spark plug Replace spark plug
Unit loaded during start up Remove load from unit
Engine will not start;
Engine starts but runs roughly Low oil level Fill crankcase to the proper level
Place log splitter on a flat, level surface
Choke in the wrong position Adjust choke
Spark plug wire loose Attach wire to spark plug
Engine shuts down during operation Out of fuel Fill fuel tank
Low oil level Fill crankcase to the proper level . Place
log splitter on a flat, level surface
Engine cannot supply enough power or
overheating Insufficient ventilation Check for air restriction . Move to a
well ventilated area
Wedge movement is slow or erratic Air in the hydraulic oil system Purge air by extending and retracting
the wedge several times until motion
is smooth
Debris lodged in beam guides Clear debris from beam
Low hydraulic oil Check oil level and add as needed
Oil leak from hose connection Loose hose clamp or hydraulic fitting Tighten hose clamp or hydraulic fitting
Oil leak from cylinder Faulty cylinder rod seal Contact Customer Service
Scored or bent cylinder rod Contact Customer Service
Loose hydraulic fitting Tighten hydraulic fitting
Faulty combination washer seal on
cylinder hydraulic fitting Contact Customer Service
Wedge will not extend or retract Faulty control valve Contact Customer Service
Faulty hydraulic pump Contact Customer Service
Low hydraulic oil Check oil level and add as needed
Wedge does not Auto-Return Low hydraulic oil Check oil level and add as needed
Faulty control valve Contact Customer Service
Excessive bouncing while towing Under-inflated tires Inflate tires to proper pressure . Refer
to tire sidewall