Champion Power Equipment 100133 - Manual (Page 14)

11
ENGLISH 100133
ASSEMBLy
8) Install the Multi-Wedge and Log Catchers
1 . Align the larger sized holes in the base of the of
multi-wedge with the larger sized holes in the end of
the beam . (A)
2 . Secure the multi-wedge with four (4) M18x62 hex
socket head bolts, ø18 washers, ø18 lock washers
and M18 nuts . (A)
3 . Tighten . Do not over tighten .
9) Install the Single Wedge and Log Catchers
1 . Align the larger sized holes in the base of the of
single wedge with the larger sized holes in the end
of the beam . (A)
2 . Secure the single wedge with four (4) M18x62 hex
socket head bolts, ø18 washers, ø18 lock washers
and M18 nuts . (A)
3 . Tighten but do not over tighten .
A A
B B
4 . Once the multi-wedge has been secured to the
beam, the log catchers can be attached to it .
5 . Align the smaller holes in the left side of the multi-
wedge with the small holes in the left log catcher .
(B)
6 . Secure the left log catcher to the multi-wedge
using the M10x25 bolts, M10 lock washers and ø10
washers . (B)
7 . Screw the M10x25 bolt directly into the threaded
holes of the multi-wedge from underneath the unit
going upwards . (B)
8 . Tighten . Do not over tighten .
9 . Repeat steps 5-7 for the right side log catcher .
10 . Once the log catchers have been secured to the
multi-wedge, secure the log catchers together, on
the bottom side, with the two (2) M10x25 bolts,
ø10 washers, and M10 nuts .
11 . Tighten . Do not over tighten .
4 . Once the single wedge has been secured to the
beam, the log catchers can be attached to it .
5 . Align the smaller holes in the left side of the single
wedge with the small holes in the left log catcher .
(B)
6 . Secure the left log catcher to the single wedge
using the M10x25 bolts, M10 lock washers and ø10
washers . (B)
7 . Screw the M10x25 bolt directly into the threaded
holes of the single wedge from underneath the unit
going upwards . (B)
8 . Tighten . Do not over tighten .
9 . Repeat steps 5-7 for the right side log catcher .
10 . Once the log catchers have been secured to the
single wedge, secure the log catchers together, on
the bottom side, with the two (2) M10x25 bolts,
ø10 washers, and M10 nuts .
11 . Tighten . Do not over tighten .