beautypg.com

Recycling, Msds – C&D Technologies RS-2061 Standby Batteries for Renewable Energy Applications User Manual

Page 14

background image

If the plates are covered by electrolyte, the battery should be placed on charge. The gases produced by

charging will displace the electrolyte and will raise it to an acceptable level between the high and low level

marks on the container. Had the level been adjusted to the “High” mark before charging, charging could have

caused the electrolyte to rise to a point where it could overflow through the vent or be forced up into the flame

arrester, requiring needless maintenance.

If, after charging, the electrolyte levels have not risen to between the high and low level lines, add distilled or

de-ionized water.

Do Not Add Acid. Adding acid is a procedure that should be done only after consultation

with C&D Technologies or performed by a C&D Technologies Manufacturers’ Representative.

NOTE: Adding water to a battery to bring the initial electrolyte levels up will reduce the specific gravity.

Watering cells and adjusting electrolyte levels in vented cells

CAUTION: Do not add water or electrolyte to VRLA cells. Removal of vents from VRLA type cells voids the warranty.

Adjust electrolyte levels only when cells are fully charged and stabilized at float voltage. Distilled or de-ionized

water is preferred for adjusting electrolyte levels. Before adding water or acid to a battery, consider its condi-

tion and state of charge. For example, a new battery, which has recently experienced vibration during ship-

ment,

Lead-acid batteries are recyclable and C&D Technologies currently has a low cost, convenient and

environmentally safe collection and recycling program. Visit the C&D website at www.cdtechno.com for

further information.

Recycling

MSDS sheets are available on C&D Technologies website at: www.cdtechno.com

MSDS

Any data, descriptions or specifications presented herein are subject to revision by C&D Technologies, Inc.

without notice. While such information is believed to be accurate as indicated herein, C&D Technologies, Inc.

makes no warranty and hereby disclaims all warranties, express or implied, with regard to the accuracy or

completeness of such information. Further, because the product(s) featured herein may be used under conditions

beyond its control, C&D Technologies, Inc. hereby disclaims all warranties, either express or implied, concerning

the fitness or suitability of such product(s) for any particular use or in any specific application or arising from any

course of dealing or usage of trade. The user is solely responsible for determining the suitability of the product(s)

featured herein for user’s intended purpose and in user’s specific application.
Copyright 2014 C&D TECHNOLOGIES, INC. Printed in U.S.A. RS02061 0514/CD

1400 Union Meeting Road

P.O. Box 3053 • Blue Bell, PA 19422-0858

(215) 619-2700 • Fax (215) 619-7899 • (800) 543-8630

[email protected]

www.cdtechno.com