Buick 2006 Rendezvous User Manual

Page 408

1. If the cable is not visible, start this procedure at

Step 3.

2. Turn the folding wrench counterclockwise until

approximately 6 inches (15 cm) of cable is
exposed.

3. Attach the folding wrench to the jack and raise the

jack at least 10 turns.

4. Place the jack under the vehicle, ahead of the rear

bumper. Position the center lift point of the jack
under the center of the spare tire.

5. Turn the folding wrench clockwise to raise the jack

until it lifts the secondary latch spring.

6. Keep raising the jack until the spare tire stops

moving upward and is held firmly in place. This
lets you know that the secondary latch has released
and the spare tire is balancing on the jack.

All-Wheel-Drive Vehicle shown

Front-Wheel-Drive Vehicle shown

5-82