Buffalo Filter ViroVac - Manual (Page 11)

2.1 System Controls
Note: Please be sure to read all instructions before installing accessories or operating this equip-
ment. Failure to do so may result in damage to the unit and/or personal injury.
• SUCTION ON & Standby
switch on the electronic membrane control panel is located in the upper right hand corner of
the membrane panel. To power up the machine, (|), connect the supplied power cord to a grounded
outlet and the appliance inlet on the back of the smoke evacuation system. Once power has been
applied, the yellow standby LED will illuminate on the keypad. Press the ON/OFF button on the
membrane panel to illuminate the “fan running” green LED indicating active suction. Place the
unit in “standby” by pressing the suction ON membrane switch to illuminate yellow STANDBY
on the unit or the receptacle in the wall.
• SUCTION CONTROL
(Membrane Control Panel)
tion control button is depressed, the motor speed in increased. Once the suction has reached the
tion control should be set at the lowest practical setting to completely remove the surgical smoke
• FOOTSWITCH / EZ LINK REMOTE ACTIVATION DEVICE
(Membrane Control Panel)
A footswitch or a EZ Link Device may be added to any system by simply plugging in a
BUFFALO FILTER activation accessory into the appropriate jack on the front of the unit. When
once for each operation. For directions on using the EZ Link Device, please see instructions
that accompany that product.
Operating Instructions
Section 2.0
, (O),