Bricasti Design M7 Mainframe Stereo Reverb Processor Owner’s Manual - Manual (Page 33)

The Reverb Parameters
The presets are crafted with care to give you a great starting place to get your sound. However,
you may want to adjust them slightly to get the sound you are looking for. This section is a
reference for the reverb parameters you can adjust and what their affect is on the overall sound.
•
Reverb Time:
Control Range:
0.1 – 30 sec
Mid-frequency reverb time. Sets the reverb time of the mid frequencies when the signal
stops.
• Reverb Size:
Control Range: Small 1 – 24 Large
Adjusts the apparent size of the late reverberant field.
• Reverb Pre Delay:
Control Range: 0 – 500 ms
Sets the amount of time which elapses between the input signal and the onset of
reverberation.
• Reverb Diffusion:
Control Range: Low 1 – 9 High
Sets initial diffusion of the reverb. Displayed and controlled as a percentage change from the
initial value defined by the preset.
•
Reverb Density:
Control Range:
Low 1 – 9 High
Sets how the echo density builds up over time.
• Reverb Modulation:
Control Range: Off, Low 1 – 9 High
Controls the amount of modulation and pitch variation in the later part of the reverberant
field.
• Roll Off:
Control Range: 80 Hz – 28 kHz
Low pass filter applied to overall output of the reverb.
• Reverb HF RT MPY:
Control Range: 0.2 – 1.0
Sets the high frequency reverb time above the crossover frequency set by the Reverb HF
Crossover control. Displayed and controlled as a scaling of the Reverb Time control.
• Reverb HF Crossover:
Control Range: 200 Hz – 16 kHz
Sets the crossover frequency used by the Reverb HF RT MPY control.
3-2