beautypg.com

Safety – Boekel Scientific 290400-2 Orbital and Reciprocating Water Baths User Manual

Page 3

background image

N2400306, August 2011, Rev 4 Shaking Hot Tub Operators Manual

3

1. Safety


The following symbols mean:

Caution: Read these operating instructions fully before use and pay

particular attention to sections containing this symbol.

Caution: Surfaces can become hot during use.


Always observe the following safety precautions:

Use only as specified by the operating instructions or the

intrinsic protection may be impaired.

 Do not place fingers or hands below the tray surface while the tray is

in motion. Only use tray handles to move the tray.

 These baths are for water use only.
 Connect only to a power supply which provides a safety earth ground.
 Take care when topping or draining, as liquid may be very hot.

Do not touch surfaces that become hot during high temperature

use.

 Ensure that the mains switch and isolating device (power supply

connector) are easily accessible during use.

 Connect only to a power supply which provides a safety earth ground

terminal.

 Before moving, disconnect at the power supply socket.

Do not connect to a power supply or switch on before filling the

tank.

 If liquid is spilled inside the unit, disconnect it from the power supply

and have it checked by a competent person.

 It is the user’s responsibility to carry out appropriate decontamination

if hazardous material is spilt on or inside the equipment.

 Clean the unit only with a damp cloth; do not use chemical cleaning

agents.

 Place unit on a solid, level work surface or laboratory bench.
 Drain tank before moving the bath. Before draining allow the unit to

cool below 50°C.

Always use a lid when operating above 60°C. Take care when

raising and removing the lid, it may be hot, steam and hot vapors can
cause scalding.