Boekel Scientific 270440 Jitterbug-4 - Manual (Page 3)

1. Safety
The following symbols mean:-
Caution: Read these operating instructions fully before use and pay particular attention to
sections containing this symbol
Caution: Surfaces can become hot during use.
Always observe the following safety precautions
Use only as specified by the operating instructions, or the intrinsic protection may be impaired.
After transport or storage in humid conditions, dry out the unit before connecting it to the supply voltage.
During drying out the intrinsic protection may be impaired.
Connect only to a power supply with a voltage corresponding to that on the serial number label.
Ensure that the mains switch and isolating device (power supply connector) are easily accessible during use.
Connect only to a power supply which provides a safety earth (ground) terminal.
Before moving, disconnect at the power supply socket.
If liquid is spilled inside the unit, disconnect it from the power supply and have it checked by a competent
person.
It is the user's responsibility to carry out appropriate decontamination if hazardous material is spilt on or
inside the equipment.
The maximum guaranteed number of diagnostic cycles in the shaker mode, which require 15-30
minutes use in one cycle, is 7000-14000 times.
Do not use external power supply units other than that recommended by the manufacturer.
Before using any cleaning or decontamination method except those recommended by the manufacturer,
user should check with the manufacturer that the proposed method will not damage the equipment.
Clean the unit only with a damp cloth, do not use chemical cleaning agents.
The unit has an air intake for cooling and ventilation. Do not block or impede the ventilation grille.
N2400304, Mar 2012, Rev. 4
Page 3
270400 and 270440
Operating Instructions