Boekel Scientific 241000-2 InSlide Out - Manual (Page 6)

5
4.4 Loading Tray into Heating Chamber
Once the Tray Assembly is loaded and the slides prepared, the tray can be loaded into the
heating chamber. Open the main door, lift the frame, pivot the latch forward (see Figure
5), and slide the Tray Assembly into the Frame Assembly until it is fully seated against
the rear of the Frame Assembly (see Figure 6). Rotate the latch into a vertical position
and position the latch over the keeper on the frame, then rotate the Latch Handle 180
˚
clockwise (see Figure 7). Rotate the Latch Handle down (see Figure 8). Close the main
door.
4.5 Removing Tray from Heating Chamber
Extreme care must be used when removing the tray due to the potentially high
temperature. It may be necessary to use gloves when removing the tray. To remove the
tray from the Heating Chamber, open the main door, lift the Latch Handle up and rotate it
180
˚ in a counter clockwise direction. Rotate the latch down, lift the frame up and
carefully slide the Tray Assembly out.
5. Accessories
5.1 Slide Holder – Catalog Number C2403765
This slide holder is made from polycarbonate and will hold 18 standard glass slides.
Figure 8
Latch
Handle
(Ready to close main door)
Figure 6
(Tray partially inserted)
Figure 7
Latch
Handle
(Fully inserted and locked)
Latch
Tray
Assembly
Frame
Assembly
Heated
Chamber
Figure 5