Boekel Scientific 145600-2 Paraffin Wax Dispenser - Manual (Page 4)

3
3. Assembly
3.1 Unpacking
Remove packing materials carefully, and retain for future shipment or
storage of the unit. Inspect for damage. Report all shipping damage to
the carrier immediately. Shipping damage is covered by the carrier and
repair/replacement for shipping damages must be coordinated through
the carrier. Complete and return the Warranty Registration Card.
Contents include:
• Wax Dispenser • Power Cord
• Lid • Warranty Card
• Operating Instructions
3.2 Installation
Place the Wax Dispenser on a flat and stable surface, preferably away
from drafts. Plug the power cord into a voltage source that matches the
voltage listed on the serial number label on the rear of the unit. Insure
that the surface on which the unit is placed will withstand the radiated
heat produced by typical laboratory equipment.
4. Operation
4.1 Controls and Indicator Lamp (see Figure 1)
1. Power Switch - Controls power to the unit.
2. Heater Control Dial – Used to set desired temperature.
3. Power on Lamp – When illuminated indicates unit is powered up.
4. Heater Indicator – When illuminated indicates heater is on.
5. Dispenser Valve –Used to dispense wax. The valve can be used to
dispense wax on demand, or rotate the handle 180° to lock the handle
into a constant flow position (See Figure 2).