Citizen Systems Citizen CLP 6001 CLP-6001 - Manual (Page 34)

3-7
3.4 Paper Setting
CAUTION Be careful of the edges of the plates so injury or
property damage is possible.
The printer is designed for easy loading of paper and ribbon. After opening the
cover, set the register paper as follows:
1 Push down the open lever 1 to move the print head out of the way.
2 Push down the lever 3 to move the sensor arm 2 out of the way.
3 Attach the roll paper and roll guide 5 to the roll holder and position it in the
paper holder 6 . After installing the roll paper, adjust the roll guide 5 to the
width of the roll paper.
The roll paper should be in its deepest position
(reference side).
4 Pull the moving paper guide 7 toward you to maintain the paper insertion
path.
5 Set the roll paper as shown in the figure.
6 Attach the left side of roll paper to the fixed paper guide 8 and let the moving
paper guide 7 slightly contact the other end of the roll so that the paper does
not skew.
7 Push down the sensor arm 2 until the lever hook is locked.
8 Align the paper with the positioning notch of the peeling-off plate 9 and then
press down the ribbon bearing flat 10 to close the print head. The open
lever hook will lock.
9 Close the cover.
10 Turn on the power to the printer. The LCD screen on the control panel will
display "On line." Press the Feed key. The paper will advance to the next
label and stop there.
(For encircled numbers, see figures on the next page.)