AvMap ULTRA UX0EFS3XAM - Manual (Page 19)

18 - User and Installation Manual
AvMap Ultra EFIS
User and Installation Manual - 19
AvMap Ultra EFIS
4.4 SETUP mode
To enter the SETUP mode from either the PFD or HSI mode keep the rotation knob
pressed for 5 seconds.
The SETUP mode provides you information regarding the software version, enabled
COM ports, V-speed values and display brightness.
In the SETUP mode push the rotation knob to enter the “SETUP” menu:
In the “SETUP” menu you can enter the following menu’s:
• CALIBRATE: To calibrate the compass and the horizon.
• DATABASE: To update the navigation POI’s.
• SETUP: To change display brightness, configure the aircraft specific V-speed values
and change units measurements.
Note: For compass and horizon calibration see Chapter 3.
Aircraft Specific V-speed reference values
Select “SPEEDS” in the “SETUP” menu to enter the V-speed reference values shown
on the bottom of the SETUP mode.
Rotate the rotation knob to change values and push the rotation knob to confirm.
Refer to the aircraft operating manual to find the correct values of your aircraft.
Navigation POI management
Ultra is preloaded with Jeppesen navigation POI’s: Airports, NDB’s and VOR’s.
In the “DATABASE” menu you can choose “IMPORT” to update navigation POI’s on the
Ultra through the microSD card. Make sure the microSD card is inserted in the Ultra.
Note: To update the navigation POI’s on your Ultra visit www.avmap.it or contact
[email protected]. Follow the update instructions that are provided together with the
POI purchase.
Display brightness
Select “BRIGHTNESS” in the “SETUP” menu to adjust the display brightness. Use
the rotation knob to change the display brightness and confirm by pushing the rotation
knob.
Units measurement settings
To change units measurement select “UNITS” in the “SETUP” menu.
You can change the following units measurements:
- NORTH: compass heading can be set in degrees with respect to magnetic north or
true north.
- PRESSURE: barometric pressure can be set in hPa or inHg.
- SPEED: All speed referred information (IAS, wind speed, ground speed, vertical speed,
aircraft V-speed range) can be set in knots, kph, mph or m/s.
- ALTITUDE: Altitude can be set in feet or meters.
- DISTANCE: Distance to an VOR or ADF navigation point can be set in nm, miles or km.