Audio Note M Zero Remote - Manual (Page 5)

optimum sonic performance is reached.
The M Zero Remote is designed for continuous operation and may remain switched on, even when not in
use. You may, however, prefer to turn the unit off between uses by using the power switch located on the
back panel, next to the mains inlet socket.
NOTE: Always turn the pre-amplifier(s) on before turning on the power amplifier and always turn the
power amplifier off before turning off the pre-amplifier. This will prevent any buzzing or popping
sounds from occurring.
After-care
Cleaning
Cleaning the M Zero Remote is best done with a soft brush - some photographic stores are able to
provide suitable brushes. Alternatively, a soft cotton cloth may be used with a mild propriety cleaner for
removing dirt build-up. Strong or alcohol based solvents may damage the finish of this amplifier. Ensure
the pre-amplifieris switched off and cold when cleaning. Do not wet the unit.
Replacing the vacuum tubes
The vacuum tubes in the M Zero Remote are carefully selected from Audio Note's vast stock to provide
optimum performance and reliability. Should these tubes require replacement, please contact your
Audio Note dealer, who will be able to supply the correct parts.
- 5 -