beautypg.com

Antari B-200 User Manual

Page 4

background image

3

Switch off from main power when refilling the liquid or cleaning the system.

Regular cleaning of the bubble wheel is required.

Install the bubble machine in a well-ventilated area. Never cover the unit’s vents. In
order to guarantee adequate ventilation, allow a free air space of at least 20 cm
around the sides and top of the unit.

Do not transport with liquid. If the machine gets wet, do not use it before it is
completely dry.

Antari bubble liquid may leave permanent marks on clothing.

Danger of Explosion

Never add flammable liquids of any kind (such as oil, gas, perfume) to the bubble
liquid.

Use only high-quality, water-based liquid that your dealer recommends. Other liquids
may cause clogging or “spitting”.

Always make sure there is sufficient liquid in the tank. Operating this unit without liquid
will cause damage to the pump.

If your ANTARI B-200 Bubble Machine fails to work properly, discontinue use
immediately. Drain all liquid from the tank, pack the unit securely (preferably in the
original packing material), and return it to your ANTARI dealer for service.

Always drain tank before mailing or transporting this unit.

Never drink bubble liquid. If it is ingested, call a doctor immediately. If liquid comes in
contact with skin or eyes, rinse thoroughly with water.

Pay attention to all warning labels and instructions printed on the exterior of your

ANTARI Bubble Machine

Unpacking & Inspection

Open the shipping carton and verify that all equipment necessary to operate the system
has arrived intact.
In addition to this user manual, the shipping carton should contain the following items:

1. B-200 Bubble Machine

2. Power cord and plug

3. 1 Mounting bracket

4. 2 pieces of tightening screws and metal screws, 5 pieces of washers, one safety ring.

If any equipment is missing contact your ANTARI dealer immediately.

Before beginning with the initial setup your Bubble Machine, make sure that there is no
evident damage caused by transportation. In the event that the unit’s housing or cable is
damaged, do not plug it in and do not attempt to use it until after contacting your ANTARI
dealer for assistance.