Antari SW-250 - Manual (Page 4)

4
Open the shipping carton and check that all equipment necessary to operate the machine have arrived intact.
The shipping carton should contain the following items:
1. Snow machine with power cable
2. W-1 wireless transmitter (Only for SW-250 model)
3. Fluid tank
4. Hanging bracket
5. Screw set and user manual
Before beginning initial setup of your ANTARI SW-250 Snow Machine, make sure that there is no evident
damage caused by transportation. In the event of that the unit's housing or cable is damaged, do not plug it
nor use it until contacting your Antari dealer for assistance.
SETUP and POWER ON
1. Remove all packing materials from shipping box. Check that all foam and plastic paddings are removed.
2. Place the machine on a flat surface and follow steps below.
Tank cap
Tank
F ilter
PU Liquid Tube
Adaptor
with Nut
A ssem b lin g Tan k & F ilt er
Please note that "adaptor w ith nut"
set must be tightly connected.
3. Assemble the hanging bracket on the machine, use the M8 screws to position the hanging bracket
with the machine, the tightening screws are for adjusting the machine’s angle when in the air.
Assembl i ng Hangi ng Bracket
Assemble 4 w asher s on both inner sides of the hanging
br acket w ith M8 scr ew s on outer sides as indicated.
Hanging Br acket
M8 Scr ew
Tightening
Scr ew
Washer
4. Fill with ANTARI SL-5(A) snow fluid. Any other types of fluid can damage the unit. When filled, place cap