Antari S-100X - Manual (Page 6)

6
2. Turn on the machine by pressing the red power switch on the rear of the unit and make
sure the red indicator that is located above the Power switch is lit .
The units can be controlled by either DMX or the SC-2 volume remote control. See the
respective topics below:
3. Connect the remote control's male 4-pin plug to the machines' INPUT socket and make
sure the red “POWER” indicator is lit.
4. Press ON/OFF button, the IN USE indicator lights up green and the machine is ready to
operate (during this procedure, the machine’s fan and motors are operating).
5. Use the adjustable knob “OUTPUT VOLUME” on the SC-2 Volume Remote controller to
set an output value between 10% and 100%.
6. There’s a smaller button “AIR VOLUME” located at rear of the machine used for adjusting
the fan output volume. In general, when the fan output is increased the snowflakes
produced are smaller. In contrast, when the fan output is decreased, bigger snowflakes will
be produced. However, the snow output volume will not be affected.
DMX Connector Pin Assignment
The machine provides a 3-pin XLR connector for DMX connection. The diagram below
indicates pin assignment information.
Pin Function
1 Ground
2 Data-
3 Data+