Antari ICE-101 - Manual (Page 6)

6
method you choose, do not allow the unit to have more than a 15 degree angle of inclination.
Important: Always monitor tank fluid level as you are fogging. Running a fog machine with
no fluid can permanently damage the unit.
If you experience low output, pump noise or no output at all, unplug immediately. Check fluid
level, the external fuse, remote connection, and power from the wall. If all of the above
appears to be O.K., plug the unit in again. If fog does not come out after holding the remote
button down for 30 seconds, check the hose attached to the tank to make sure there is fluid
going through the hose. If you are unable to determine the cause of the problem, do not
simply continue pushing the remote button, as this may damage the unit. Return the
machine to your ANTARI dealer.
Remote Control Operation:

Z-8: 25 feet wired multi-function remote control with 4-PIN XLR connector for ANTARI
ICE-101.
․ Interval knob: Rotate it to set the interval time between fog outputs in the Timer
mode. The range is from 10 to 250 seconds.
․ Duration knob: Rotate it to set the duration time of fog output in the Timer mode.
The range is from 1 to15 seconds.
․ Output knob: Rotate it to set the volume of fog output. The range is from 0% - 100%
of maximum output.
․ To press the yellow Timer button can activate Timer mode.
․ To press the red Continuous button can make the machine generate fog output
constantly. The fog output is set by Output knob. Please note that when the
temperature of heater is too low, the machine stops producing fog and starts to
reheat. Once the reheating process is completed, the machine can continue to
produce fog output.