Antari ICE-101 - Manual (Page 4)

4
guarantee adequate ventilation, allow a free air space of at least 20 cm around the sides
and top of the unit.
♦ Never aim the output nozzle at open flames.
♦ The output nozzle becomes very hot during operation (300°C). Keep flammable materials
at least 50 cm away from the nozzle.
♦ Always allow your ANTARI Fog Machine to cool down before attempting to clean or service
it.
Danger of explosion
♦ Never add flammable liquids of any kind (oil, gas, perfume) to the fog liquid.
Pay attention to all warning labels and instructions printed on the exterior of your ANTARI
Fog Machine
♦ Use only the high-quality, water-based fog liquid that your dealer recommends. Other fog
liquids may cause clogging or “spitting”.
♦ Always make sure there is sufficient liquid in the fog liquid tank. Operating this unit ithout
liquid will cause damage to the pump as well as over-heating of the heater.
♦ If your ANTARI Fog Machine fails to work properly, discontinue use immediately. Drain all
fog liquid from the tank, pack the unit securely (preferably in the original packing material),
and return it to your ANTARI dealer for service.
♦ Always drain tank before mailing or transporting this unit.
♦ Never drink fog liquid. If it is ingested, call a doctor immediately. If fog liquid comes in
contact with skin or eyes, rinse thoroughly with water.
Unpacking & Inspection
Open the shipping carton and verify that all equipment necessary to operate the system has
arrived intact. Refer to the “Features” section for information on what items are included with
your model. If any equipment is missing contact your ANTARI dealer immediately.
Before beginning initial setup of your ANTARI Fog Machine, make sure that there is no
evident damage
caused by transportation. In the event that the unit’s housing or cable is
damaged, do not plug it in and do not attempt to use it until after contacting your ANTARI
dealer for assistance.