ALM ALM006 - Manual (Page 8)

• Only use with pedals which use cable tip for input (aka tip to potentiometer wiper
or tip for return signal) not reference voltage. Most pedals are setup like this. If in
doubt check with your pedal manufacturer.
ALM accepts no responsibility in damage done though mis-use!
Bonus Patch Ideas
DISTORTION - Patch the S.B.G in reverse; DRY|WET to Full CCW. Signal in to Return
in, return out to send in, send out is distorted signal. Adjust RETURN knob till clip LED
lights, then lower outgoing signal with SEND attenuator.
General signal amplification - With DRY|WET set to full CW use the right hand side
return input and output can be use to amplify external signals to modular levels. This
is also useful for amplifying Pamela firmware update audio files to expected levels.
ALM-006 - ‘S.B.G’
8