ALM ALM006 - Manual (Page 6)

To correctly set levels;
• Set pedal output to fully wet (mix or blend etc to maximum setting) so the pedal
output is fully saturated with its effect. This is important.
• Connect pedal to SBG as indicated in the above diagram. Use 1/4” to 1/8” jack
adaptors if needed to connect to pedal.
• Turn DRY|WET knob fully CW.
• Starting with both the SEND and RETURN mini potentiometers at approx 9 o'clock
adjust until a clean fully wet signal is heard:
• The SEND mini pot ATTENUATES (lowers) the signal sent to the pedal. If you hear
small clicks or distortion in the returned signal you likely need to INCREASE the
attenuation thus lower the outgoing signal by turning the knob CCW.
• The RETURN mini pot AMPLIFIES the return signal to modular levels. If the red LED
lights the signal is too loud and thus distorting. Reduce the signal level by turning
CCW.
• Once you can hear a clean fully wet signal you are happy with adjust the DRY|WET
knob to taste re-introducing the original dry signal. The WET|DRY knob mixes
between the original non attenuated input signal and the amplified returned
signal.
ALM-006 - ‘S.B.G’
6