Crimestopper Security Products CS-2013FM - Manual (Page 25)

SPECIAL 2-WAY LCD FM REMOTE-PAGER FUNCTIONS
Clock Setting:
1. Press and hold buttons #2 (Key Symbol) & #3 (Trunk Symbol) together until 2 beeps are heard.
2. Immediately release Buttons #2 & 3.
3. Observe the time display on the LCD screen. Press the #2 button to set the hour and press the #3 button the set minutes.
4. When the correct time is displayed, press button #5 (C) to set the time. The remote will emit a congratulation song and
the correct time of day will now appear at the top of the LCD screen.
Alarm Clock Setting:
1. Press and hold buttons #2 & #3 together for the following sequence: [2 beeps]-[3 beeps]. If done correctly, the Alarm
Clock Icon will appear.
2. Immediately release Buttons #2 & #3.
3. Observe the alarm time display on the top of the LCD screen. Press the #2 button to set the Hour and press the #3 button
the set minutes for any desired alarm time.
4. Press button #5 (C) to set the alarm time. The remote will emit a congratulation song and an alarm clock icon will display
next to the time of day on the LCD as an indicator the alarm has been set. Note: Alarm clock sounds one time for
each setting. Follow steps 1, 2, and 3 to reset alarm for a new time or follow steps 1 & 3 only to set alarm for same time
again.
To cancel an alarm that has already been set:
1. Press and hold buttons #2 & #3 together for the following sequence: [2 beeps]-[3 beeps].
2. Immediately release Buttons #2 & #3. The alarm clock icon should appear on the display.
3. Press button #1. The remote will emit a set of tones and the word “OFF” will appear for 5 seconds on the LCD screen.
Self-Start Timer:
1. Press and hold buttons #2 & #3 together for the following sequence: [2 beeps]-[3 beeps]-[4 beeps]. If done correctly, the
Engine Icon will appear on the LCD screen.
2. Immediately Release buttons #2 & #3.
3. Observe the time display in the top of the LCD screen and press the #2 button to set the Hour and press the #3 button to
set the minutes for any desired remote start time.
4. Press button #5 (C) to set the remote start time and the remote will emit a congratulation song. A clock and an engine
icon will display indicating the remote start timer has set. Note: The Remote Start Timer activates once for each
setting. Vehicle must be within range of the remote control! Follow steps 1, 2, and 3 to reset timer for a new time or
follow steps 1 & 3 only to set the timer for the same time again.
To Cancel Self-Start timer:
5. Press and hold buttons #2 & #3 together for the following sequence: [2 beeps]-[3 beeps]-[4 beeps].
6. Immediately release Buttons #2 & #3. The Engine Icon should appear on the LCD display.