Keys and locks – Acura 2002 TL - Owner's Manual User Manual
Page 85
To turn it back on, repeat this
procedure. The LED will come on
for one second to indicate the
feature has been turned on.
If the seat and mirrors are already in
the proper positions, you will hear
three beeps when you open the door.
The driving position memory
activated (Memory 1, Memory 2) is
shown on the back of each
transmitter. Make sure you store
your desired driving position in the
memory that is activated by the
transmitter you normally carry.
You can turn off this driving position
memory activation. Press and hold
the LOCK and UNLOCK buttons at
the same time. The LED in the
remote transmitter will blink twice.
Then release the buttons.
The remote transmitters will also
activate the Driving Position
Memory System (see page
).
When you open the driver’s door
after unlocking it with the remote
transmitter, you will hear a beep.
The driver’s seat and outside mirrors
move to the positions stored in that
memory location. You will hear two
beeps when the movement is
complete.
Panic mode allows you to remotely
activate your car’s security system to
attract attention. When activated, the
horn will sound, and the exterior
lights will flash, for about 30 seconds.
To activate panic mode, press and
hold the PANIC button for about two
seconds.
To cancel Panic mode before 30
seconds, press any button on the
remote transmitter. You can also
turn the ignition switch to ON (II).
Panic mode will not activate if the
ignition switch is in the ON (II)
position.
Keys and Locks
Instruments and Controls
Recalling a Memorized Driving
Position
Panic Mode
82
W
W
i
i
t
t
h
h
M
M
e
e
m
m
o
o
r
r
y
y
1
1
W
W
i
i
t
t
h
h
M
M
e
e
m
m
o
o
r
r
y
y
2
2
00/12/25 14:07:28 31S0K630_085
Main Menu