Acura 2002 MDX - Owner's Manual - Manual (Page 67)

This indicator comes on for a few
seconds when you turn the ignition
switch ON (II). It will then go off if
you have inserted a properly-coded
ignition key. If it is not a properly-
coded key, the indicator will blink
and the engine will not start (see
page
).
This indicator also blinks several
times when you turn the ignition
switch from ON (II) to ACCESSORY
(I) or LOCK (0).
This light normally comes on for a
few seconds when you turn the
ignition switch ON (II), and when
the ignition switch is turned to
START (III). If this light comes on at
any other time, there is a problem in
the ABS. If this happens, take the
vehicle to your dealer to have it
checked. With the light on, your
vehicle still has normal braking
ability but no anti-lock. For complete
information, see page
.
This light has two functions:
This indicator comes on when you
turn the ignition switch ON (II). It
is a reminder to check the parking
brake. Driving with the parking
brake not fully released can
damage the brakes and tires.
If the indicator remains lit after
you have fully released the
parking brake while the engine is
running, or if it comes on while
driving, it can indicate a problem
in the brake system. For complete
information, see page
.
1.
2.
80
331
221
Indicator Lights
Instruments and Controls
Immobilizer System
Indicator
Anti-lock Brake System
(ABS) Indicator Parking Brake and Brake System
Indicator
63
U.S. Canada Canada U.S.
01/09/07 12:05:42 31S3V610_068
Main Menu Table of Contents