Acura 2006 TL - Owner's Manual - Manual (Page 85)

Push down on the
lever to signal a left turn and up to
signal a right turn. To signal a lane
change, push lightly on the lever,
and hold it. The lever will return to
center when you release it or
complete a turn.
The rotating switch
on the left lever controls the lights.
Turning this switch to the ‘‘
’’
position turns on the parking lights,
taillights, instrument panel lights,
side-marker lights, and rear license
plate lights. Turning the switch to
the ‘‘
’’ position turns on the
headlights. If you leave the lights on
with the key removed from the
ignition switch, you will hear a
reminder tone when you open the
driver’s door.
To switch from low
beams to high beams, push the left
lever forward until you hear a click.
The blue high beam indicator will
come on (see page
). Pull it back
to return to low beams. To flash the
high beams, pull the lever back
lightly, then release it. The high
beams will stay on as long as you
hold the lever back.
Turn Signal
Off
Parking and instrument panel
Headlights on
Fog lights off (U.S. models)
Fog lights on (U.S. models)
High beams
Flash high beams
The headlights revert to normal
operation when you turn them on
with the switch.
With the headlight switch off or
position, the high beam
headlights come on with reduced
brightness when you turn the
ignition switch to the ON (II)
position and release the parking
brake. They remain on until you turn
the ignition switch off, even if you
set the parking brake.
1.
2.
3.
4.
5.
6.
7.
8.
63
Canadian models only
Turn Signal and Headlights
Turn Signal
Headlights
High Beams
Daytime Running Lights
84
Main Menu Table of Contents