Acura 2014 TSX Sport Wagon - Owner's Manual - Manual (Page 291)

uu If a Tire Goes Flat u Changing a Flat Tire
290




1. Place the jack under the jacking point
closest to the tire to be changed.
2. Turn the end bracket (as shown in the
image) clockwise until the top of the jack
contacts the jacking point.
u Make sure that the jacking point tab is
resting in the jack notch.
3. Raise the vehicle, using the extension
bar and the jack handle, until the tire is off
the ground.
■ How to Set Up the Jack 1 How to Set Up the Jack
Do not use the jack with people or luggage in the
vehicle.
Use the jack provided in your vehicle.
Other jacks may not support the weight (“load”) or
their shape may not match.
The following instructions must be followed to use
the jack safely.
• Do not use while the engine is running.
• Use only where the ground is firm and level.
• Use only at the jacking points.
• Do not get in the vehicle while using the jack.
• Do not put anything on top of or underneath the
jack.
3 WARNING
The vehicle can easily roll off the jack,
seriously injuring anyone underneath.
Follow the directions for changing a tire
exactly, and never get under the vehicle
when it is supported only by the jack.
Wheel Nut Wrench as Jack Handle
Extension
Bar
14 ACURA TSX 5D-31TL76300.book 290 ページ ２０１３年６月１７日 月曜日 午後３時２１分
QRG
Index
H
a
n
d
li
ng
th
e Un
ex
pe
ct
e
d
TOC
2014 TSX Sport Wagon