Your vehicle is equipped with head restraints in all seating positions. Head
restraints are most effective for protection against whiplash and other rear-
impact crash injuries.
The center of the back of the occupant’s head
should rest against the center of the restraint.
The tops of the occupant’s ears should be level
with the center height of the restraint.

To raise the head restraint: Pull it upward.
To lower the head restraint: Push it down
while pressing the release button.
To remove the head restraint: Pull the
restraint up as far as it will go. Then push the
release button, and pull the restraint up and
out.
To reinstall a head restraint: Insert the legs
back in place, then adjust the head restraint to
an appropriate height while pressing the release
button. Pull up on the restraint to make sure it
is locked in position.

Position head in the

center of the head

restraint.

Front seat

Rear seat

For a head restraint system to work properly:

• Do not hang any items on the head restraints or from the restraint legs.
• Do not place any object between an occupant and the seat-back.
• Install each restraint in its proper location.

Improperly positioning head restraints reduces their effectiveness and increases the

likelihood of serious injury in a crash.
Make sure head restraints are in place and positioned properly before driving.

Failure to reinstall, or correctly reinstall, the head restraints can result in severe

injury during a crash.
Always replace the head restraints before driving.

WARNING

Floor Mats

Position the front and rear seat floor mats
properly and anchor them. If they are not properly
positioned, the floor mats can interfere with the
front seat functions.
Do not put additional floor mats on top of the
anchored mats.

Rear Seats

Separately fold down the left and right halves of the rear seat to make room for
cargo.

1. Store the center seat belt by inserting the latch

plate into the slot on the side of the anchor
buckle.

2. Retract the seat belt into the holder on the

ceiling.

3. Lower the center head restraint to its lowest

position. Put the armrest back into the seat-
back.

4. From the rear door side or cargo area side, pull

the release lever.

To return the seat to its original position, pull up
the seat-back to an upright position until it is
securely latched into place. Reposition the seat
belts as necessary.

Pull

Lever

Unlock

Lock