Acronova XB-42 User Manual

Page 18

Operation Manual, Xymba XB-42

V108

Important:
To verify your written data, press the Function Key which
will light up its LED and then press the High or Safe-Speed
Duplication button to start.

Important:

The Xymba will save the latest master disc image, for future
duplication, on the hard disk until a new master disc has been
read. This is the case even if the Xymba has been turned off or
restarted after a previous session has completed.

If using multiple master discs to produce different quantities of
duplicate discs, repeat steps 1 and 2 to load additional sets of masters
and blank discs. Then, press the High or Safe-Speed Duplication
button to start duplicating discs. The illustration below shows an
example of three disc sets, stacked in interleave mode with one on top
of another, for multiple-to-multiple duplication,

Duplication Simulation

This mode is used to test discs for writing by emulating a duplication
session and will not actually write to the discs. Follow the steps below
to start a duplication simulation session:

1) Load the master disc into the disc loader.

2) Load the desired quantity of blank discs on top

of the master disc.

3) Press the Test/Abort button to start. Xymba

will run the operation until the disc loader is
empty.