Acronova XB-42 User Manual

Page 16

Operation Manual, Xymba XB-42

V108

Finish Disc Bin is Full or Out-of-Position

Once the Finish Disc Bin is full, Xymba will immediately pause the
duplication session including any disc in the process of unloading.
The LED indicator status will show an error. To resume the session,
clear the Finish Disc Bin, return it to position and press any key.

Turning Xymba On

Follow the steps below to get your Xymba ready:

1) Connect the power cord to Xymba and a wall outlet.

2) Turn the power switch to the On position.

Xymba will enter the initialization process and will remove
any discs inside the optical recorders. During initialization,
the LED indicators will run in sequence. Please be patient
until the initialization process has completed.

When initialization is complete, you will see the Test/Abort
indicator light up signaling that Xymba is ready to start a
duplication session. To turn Xymba off, turn the power
switch to the Off position. In case there is a duplication
session underway, abort or wait until it has completed.

Important:

The Finish Disc Bin must be in position during operation.
Removing the Finish Disc Bin will stop Xymba from operating
immediately after the active disc has completed writing.

Turning Xymba Off

To turn Xymba off, turn the power switch to the Off position. In case
there is a session underway, abort or wait until it has completed.

Although it is fine to leave the power cord plugged in, it is
recommended that you unplug the cord for increased safety when
Xymba is not used for extended periods of time.