Cisco BEFCMU10 - Manual (Page 13)

9 Chapter 5: Installing the USB Driver for Windows 2000
Instructions for Installing the Driver
Cable Modem with USB and Ethernet Connections
6. On the Driver Files Search Results screen, click the Next button.
7. When Windows 2000 has finished installing the driver, the Completing the Found New Hardware Wizard
screen will appear. Click the Finish button.
8. The Windows 2000 driver installation is complete. Contact your cable ISP to activate your account. Your cable
ISP will need the MAC address for the Cable Modem in order to set up your account. The 12-digit MAC
address is printed on a bar code label on the bottom of the Cable Modem. Once you have given them this
number, your cable ISP should be able to activate your account.
Congratulations! The installation of the Cable Modem is complete.
Figure 5-4: Driver Files Search Results
Figure 5-5: Driver Installation Complete
NOTE: To activate your high-speed Internet account,
you must contact your cable ISP after you have
connected the Cable Modem.