Panasonic EW-BW10W - Manual (Page 25)

I Troubleshooting
Display Status before error Cause and solution
UOiis
displayed.
The indication disappears in
the middle of the operation,
(the ■! 3 mark is displayed.)
Batteries are exhausted.
(Please see page 9.)
Uliis
displayed.
Pressurization to more than
280 mmHg was performed.
(Cuff pressurizes several
times.)
Were measurements taken
according to the proper
procedure and in the correct
posture?
(Please see pages 12 and 13.)
Pressure decreased
suddenly.
Is the cuff wrapped properly?
(Please see pages 10 and
11.)
The heart mark T blinked
only a few times or not at all.
Cuff does not inflate.
Your hand or wrist moved.
Has the unit detected
movement?
(Please see page 17.)
FO
|is
displayed.
Failure of the main unit
Take it to the store where it
was purchased for testing
and repairs.
Symptom Possible cause
The SYS or DIA is
high.
• The pressure cuff is positioned too low.
(Please see pages 12 and 13.)
• The pressure cuff is not wrapped around the
wrist properly.
(Please see pages 10 and 11.)
• The person is moving or talking when the
measurement is being carried out.
(Please see pages 12 and 13.)
The SYS or DIA is
low.
• The position of the pressure cuff is too high.
(Please see pages 12 and 13.)
• The person is moving or talking when the
measurement is being carried out.
(Please see pages 12 and 13.)
1Д1ИЯ 24