I fitting the pressure cuff – Panasonic EW-BW10W User Manual

Page 12

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

I Fitting the Pressure Cuff

(cont.)

2. Firmly wrap and fasten using

the hoop and loop fastener.

• A loosely applied pressure

cuff will result in high blood

readings or incapable
measurement.

• Press fastener softly to avoid

the peel off.

Do not remove the hoop and loop

fastener by twisting it off.

Be sure to peel it in an horizontal

direction in alignment with the cuff.

Fit as shown in the figure.

The cuff can be used on either wrist.

However, the difference in blood
pressure between the left and right

wrists may be around 10 mmHg, so

be sure to always use the same wrist

far measurements.