Celestron NexStar GPS 93507 User Manual

Page 6

Place the center leg brace between the tripod legs
and tighten the tension knob so that the brace
pushes out against the legs. Loosen the extension
clamp at the end of each tripod leg and slide down
the inner portion of the leg to the desired height.
Tighten the extension clamp to hold the legs in
place.

Tension

Knob

Leg
Extension
Clamp

Center Leg

Brace

With the tripod set up outside, lift the telescope by the
carrying handle on each fork arm and carefully lower it
onto the tripod head. Make sure that the hole in the
bottom of the drive base goes over the positioning pin in
the center of the tripod head. Rotate the base until the
holes line-up with the mounting holes on the tripod.
Thread the three mounting bolts from underneath the
tripod head into the bottom of the telescope base.

Attach the included accessories (eyepiece, diagonal and
finderscope) and remove the front lens cover. Align the
finderscope on a distant object. (For instructions on
aligning the finderscope, see the Assembly section of the
manual).

Eyepiece

Star

Diagonal

Finderscope

Tripod Head

Drive Base

Mounting

Bolt

Carrying

Handle

Carrying
Handle

Positioning
Pin

Altitude

Clutch

Lock Lever

Loosen the Altitude Clutch Lock Lever and rotate
the telescope tube upwards until it is level with the
ground. Tighten the Lock Lever.