Jaclo Thermostatic extension kit - J-TH34-EXT - Manual (Page 4)

3 INSTALLING AND TIGhTENING STOP LOCkNuTS
Objective: Install locknuts for check stops and thermal cartridge.
› Place thermal valve body on table with cold inlet on the right and hot inlet on the left.
› Install hot and cold check stop lock nut by placing over top of check stop and tighten to a snug fit
using a
13 ⁄
16
" socket wrench and ratchet. Figure 3.1
› Install cartridge locknut by placing over top of thermal cartridge and tighten to a snug fit using 1¼"
socket wrench and ratchet.
Figure 3.2
›
Note: After tightening the locknut on thermal cartridge, verify that the cartridge did not turn
from the 12 o'clock position. Adjust as necessary.
Figure 3.3
3.1
3.2
3.3
J-TH34 | PG 4
Black tic mark is aligned with (S)
on north side of valve.