Jaclo ½" thermostatic valve - J-THVC12 User Manual
Page 9
JACLO.COM
| PG 9
THERMOSTATIC WALL VALVE
PROCEDURE TO FLUSH THERMOSTATIC VALVE
1
›
Shut off water supply to valve.
2
›
Remove stop nut and check valve/stop (hot & cold). Rotate to make removal easier.
3
›
Screw in flushing adapters (hot & cold).
4
›
Turn on water. Flush for 30 seconds to remove any debris from lines.
5
›
Remove flush adapters (hot & cold).
6
›
Reinstall check/valve stop (hot & cold) and stop nut. Rotate to make installation easier.
This manual is related to the following products:
- Dual lever therm - T6592- Dual lever ½" thermostatic valve with integral volume control - T6570- Contemporary thumb and lever - T6572- ½" therm extension kit - J-THVC12-EXT Cross and lever dual therm - T6534- Dual lever therm valve - T6536- Dual mini lever therm valve - T6000- Contemporary cross and lever - T6530- Contemporary dual lever - T6532-