Inovonics Radius - Manual (Page 20)

Reports
6.24.13 06324C © Inovonics, 2013 - www.inovonics.com 19
• Maximum Alarm Response Time: Select to see only alarms that were
active for less than this number of minutes.
• Select Report Dates: Select one of the commonly requested report
durations or create a custum range to filter results.
4 Click “Display Report.”
5.1.2 Average Alarm Response Time
The average alarm response time report shows the average amount of time
alarms are active within the Radius system.
To display an average alarm response time report:
1 From the home screen, click “Reports.”
2 Click “Average Alarm Response Time.”
3 Select options to refine your report. Any field can be left blank to select all.
• Mode: Select a specific mode to filter report results by mode.
• Monitored Event Device: Select monitored devices in a category to filter
report results by monitored device type.
• Show ‘Display Only’ Events: Select to see only events that are displayed
on the web interface without sending alerts.
• Minimum Alarm Response Time: Select to see only alarms that were
active for greater than this number of minutes.
• Maximum Alarm Response Time: Select to see only alarms that were
active for less than this number of minutes.
• Select Report Dates: Select one of the commonly requested report
durations or create a custum range to filter results.
4 Click “Display Report.”
5.1.3 Track Mobile Devices
The track mobile devices report shows the location of all mobile devices that
have been set up using the Inovonics positioning system.
To see tracked mobile devices:
1 From the home screen, click “Reports.”
2 Click “Track Mobile Devices.”
3 The following sortable information will display.