FRITSCH PULVERISETTE 0 - Manual (Page 37)

7.2.7.3 Releasing the TorqueMaster
The TorqueMaster clamping device is also released with the cordless
screwdriver.
The clamping unit is released far enough so that it can be placed behind
the device without changing the toothed belt clamp in the belt clamping
device.
The clamped toothed belts on the belt clamping device is only released
or adjusted, when the number or height of the sieves in the sieve stack
changes.
7.2.7.4 TorqueMaster malfunctions
For all functions, the two indicators of the clamping unit must be in the
green area. If one or both indicators are in the red area, proceed
according to the following table.
Malfunction Possible causes Rectify fault
Both indicators in outer red area Clamping unit open too much Open the clamping unit to a lesser
degree, the toothed belt clamp is
possibly too tight and must be loos-
ened by one tooth at the belt
clamping device on both sides.
Clamping unit must be opened far
enough to allow it to be deposited /
clamping unit not attached according
to instructions
Attach according to instructions.
Both indicators in inner red area
respectively
Clamping unit closed too much /
clamping unit not attached according
to instructions
Attach according to instructions.
An indicator in red area on one side Clamping system attached "very"
asymmetrically
Attach according to instructions.
Make sure that the toothed belt is
fastened symmetrically in the belt
clamping device.
7.2.7.5 Compatibility
The TorqueMaster must be used with the toothed belt clamping device
(03.3120.00). The design and proper use of this combination will rule out
any damage to the toothed belt.
Generally, the TorqueMaster can also be used with the older belt
clamping device (03.1210.00). However, this combination leads to
increased wear and is therefore not recommended.
Accessories
- 37 -