Erica Synths DIY Polivoks(ish) ADSR EG kit - Manual (Page 7)

step➊
First let’s configure gate and trigger for Active High (Roland, eurorack,
etc.) or Active Low (Korg) response! Most probably you will use Active
High gate, therefore use wire jumpers to jump AH connectors.
step➋
Now we need to deform characteristics of potentiometers. Use SMD
resistors and solder them across Attack, Decay and Release potentiom-
eters as shown on pictures below! First apply some solder on one area
of the pot, then solder the SMD resistor here, and finally solder another
end of the resistor.
BUILDING INSTRUCTIONS