Eowave Eobody2 USB8 SensorBox - Manual (Page 8)

USB 8 sensor interface / Connections
II. Connections
II.1 Step 1: Connect a sensor to Eobody2
Eowave sensors compatible with the usb eobody2 interface have TRS 1/4’’ jack connectors.
Note that Eowave sensors that were compatible with Eobody1 are also compatible. Other kind of
sensors can also be used (See “Make my own sensor” section).
Note that this is highly recommanded to connect the sensors to Eobody2 before starting your
sequencer software. Unplugging sensors while using your sequencer software may cause breaks
during the usb data transmission which could lead you to restart your software.
step 2
Connection
to your computer
step 1
Connect
your sensor
1 2 3 4 inputs 5 6 7 8
ac tiv ity
2 www.eow ave .com
int era cti ve s en sor s yst em
inputs
usb sensor box
1 2 3 4 inputs 5 6 7 8
ac tiv ity 2 www.eow ave .com int era cti ve s en sor s yst em
inputs
usb sensor box
1 2 3 4
inputs
5 6 7 8
ac tiv ity
2 www.eow ave .com
int era cti ve s en sor s yst em
inputs
usb sensor box
To connect a sensor to Eobody2, just plug the TRS 1/4’’ jack
in one of the female jack in from Eobody2 (inputs 1 to 8).
Sensors like accelerometers need 2 inputs. (See Sensors
available for sensor technical specs)
step 4
Open
your sequencer
step 3
Open
Eobody2 Editor