Cub Cadet MTD 70 Series - Manual (Page 59)

F UEL S YSTEM AND G OVERNOR
53
4. To install the air door, turn the blower housing upside
down.
5. Hold the air door in place while sliding in the rod.
NOTE: Make sure the rod goes through all of the rod
channels. See Figure 4.37.
Temperature compensating auto choke
Some engines are equipped with a temperature com-
pensating auto choke.The autochokes function the same
as described in the previous sections, however a tempera-
ture compensator is installed on the muffler. As the muffler
heats up, a bi-metallic coil inside will expand. The expand-
ing coil will rotate a lever towards the muffler, pulling on a
rod. This rod will override the autochoke, holding the
choke open on hot restarts.
To remove/replace the temperature compensator:
1. Remove the shroud.
2. Remove the two screws that hold the compensator to
the muffler using a 10 mm wrench. See Figure 4.38.
3. Unhook the compensator from the choke rod.
4. Install the compensator by following the previous
steps in reverse order.
Figure 4.37
Rod channels
Figure 4.38
Temperature Compensator
Choke rod