Canon D1 - Manual (Page 11)

1-4 Section Descriptions
[2] Trim Section
Each booklet delivered from the Infeed Section is trimmed along its fore-edge, and then moved
to the booklet lifter section. To pull out the trim unit, hold the green handle.
1
2
1 2
Transport Belts
These belts move the
booklets.
Trim Section
Transport Belt Unit
[TC4]
When booklets jam in
the trim section, hold the
handle with green label
and open this mecha-
nism to remove the
jammed booklets.
Trimmer Booklet
Waste Tray
Trim is collected in this
tray. When it is full, the
host machine displays
an error message.
If trim drops off inside
the machine when this
tray is pulled out,
make sure to remove
the dropped trim.
Trim Section
Entrance Transport
Belt Unit [TC3]
If a booklets jam in the trim
section entrance, hold the
green handle and open
this mechanism to remove
the jammed booklets.
Opening the
Transport Belt Unit
1. Hold and press the
handle.
2. Open to the right.
Opening the Transport Belt Unit
1. Hold and press the handle.
2. Pull to the right.
3. Lift the mechanism up.
Handle [TC2]
Hold this green
handle and pull out the
trim unit.
Manual Hand Wheel [TC1]
When booklets jam between the Infeed sec-
tion and the trim section, turn this hand wheel
clockwise and transport the booklet com-
pletely to the trim section. Then pull out the
trim unit and remove the jammed booklet.
When removing jammed booklets from
the trim section, take care not to touch
the blade edge.
CAUTION
Removing Jammed Booklet in Infeed Section
1. Remove the jammed booklet from the space here.