Cub Cadet GT-2554 - Manual (Page 19)

19
SECTION III. ADJUSTMENTS
This section contains information for the various
adjustments on the tractor. Adjustment information for
the mower deck is located in Section V – Mower Deck.
ADJUSTING THE SEAT
WARNING: Do not adjust the seat when
the tractor is moving. Adjusting the seat
while the tractor is moving could cause
the operator to lose control of the tractor.
Both seat arm rests can be rotated upward for mount-
ing and dismounting the tractor, or for the personal
comfort of the operator.
Before starting the tractor, adjust the seat forward or
rearward to the most comfortable driving position. To
reposition the seat, move the seat adjustment lever
(See Figure 11) toward the left and slide the seat
forward or rearward. Release the adjustment lever
when the seat is comfortably positioned. Gently rock
the seat forward or rearward to be sure the seat is
locked in place.
Figure 11
ADJUSTING THE BRAKES
During normal operation of this tractor, the brakes are
subject to wear and will need periodic examination and
adjustment.
To check the brake adjustment, position the tractor on
a firm and level surface. Stop the tractor engine and
remove the ignition key. Pull and lock the transmission
release lever in the “TRANSMISSION RELEASED”
position. Perform the following checks:
1. Engage the brake pedal lock. If the tractor can be
pushed forward or rearward, the braking force
must be increased.
2. Release the brake pedal lock. If the tractor cannot
be pushed forward or rearward, the braking force
must be decreased.
To adjust the braking force proceed as follows (Refer
to Figure 12):
1. Place the tractor on a level surface with the brake
pedal lock disengaged. Stop the tractor engine
and remove the ignition key.
2. Working from the under right side of the tractor, at
the brake pedal shaft, locate the front threaded
end of the brake rod:
• Remove the internal cotter pin from the brake
rod adjustment ferrule and withdraw the ferrule
from the brake cam. See Figure 12.
• Loosen the hex flange insert lock nut from
against the ferrule.
To increase the braking force —
Turn the ferrule clockwise (inward) one full turn at
a time until the ferrule can be inserted into the
brake cam while applying a minimal tension on
the spring.
To decrease the braking force —
Turn the ferrule counterclockwise (outward) one
full turn at a time until the ferrule can be inserted
into the brake cam while applying a minimal
tension on the spring.
3. Turn the ferrule counterclockwise (outward) one
full turn to release the slight spring tension.
Tighten the hex flange insert lock nut against the
ferrule, then insert the ferrule into the brake cam
and secure with the internal cotter pin.
Figure 12
Recheck the brake adjustment to ensure proper brake
operation before operating the tractor. If brake rod
adjustment does not correct the problem, see your
authorized Cub Cadet dealer.
SEAT
ADJUSTMENT
LEVER
Move Lever
to Left
SPRING
BRAKE
INTERNAL
ADJUSTMENT
FERRULE
BRAKE
CAM
HEX FLANGE
Viewed from top (fender off)
COTTER PIN
ROD
INSERT LOCK NUT