Cub Cadet 7252 - Manual (Page 24)

24
USING THE AUXILIARY HYDRAULIC VALVE
(IF EQUIPPED)
Some tractors may be equipped with an auxiliary
hydraulic valve package. This package provides
two hydraulic circuits for operating optional
equipment that can be installed on the tractor.
The male and female hydraulic couplers, located
beneath the right running board, are marked with
color coded washers that should match the color
coded hydraulic lines of Cub Cadet equipment. See
Figure 24.
IMPORTANT: If color coding is not present, note
that the inner hydraulic couplers represent one
hydraulic circuit and the outer couplers the
other. Do not cross connect circuits when
connecting hydraulic lines of optional
equipment.
Figure 24
Using the Auxiliary Hydraulic Control Handle
Use the auxiliary hydraulic control handle located
on the right fender as follows:
• Pull the handle rearward to raise the front
hitch or front loader boom. See Figure 25.
Figure 25
• Push the handle forward to lower front hitch
or front loader boom. Refer to Figure 25.
• Push the handle fully forward until it locks in
the detent position to place the front hitch or
front loader boom in the float position.
• Push the handle to the right to angle (if
equipped) the front hitch to the right or dump
the loader bucket. Refer to Figure 25.
• Pull the handle to the left to angle (if
equipped) the front hitch to the left or roll
back the loader bucket.
INNER
COUPLERS
OUTER
FEMALE
COUPLER
OUTER
MALE
COUPLER
ANGLE RIGHT
ANGLE LEFT
RH FENDER
COVER
DUMP BUCKET
ROLLBACK
LOWER HITCH
FLOAT HITCH
RAISE HITCH
RAISE BOOM
BUCKET
LOWER BOOM
FLOAT BOOM