Cub Cadet CC 949 - Manual (Page 8)

Self-Propelled Mower
4
4. TRANSMISSION AND CHAIN CASE
REMOVAL
4.1. Disconnect the spark plug wire and ground it to
an engine bolt.
4.2. Take measures to prevent fuel from leaking from
the gas tank.
4.3. Remove the blade as described in the blade
removal section.
4.4. Remove the belt, wheels and shroud as
described in the belt removal section.
4.5. Remove the handlebar by removing the wing
nuts and hair pin clips. See Figure 4.5.
NOTE: When reinstalling the wing nuts, make
sure they are on the out side of the handle bars.
4.6. Remove the bolt that anchors the transmission
to the deck. See Figure 4.6.
4.7. Remove the nut that holds the height adjuster
handle on using a 7/8” wrench.
4.8. Remove the hairpin clip that holds the height
adjuster linkage to the lever. Disconnect the
height adjuster linkage. See Figure 4.8.
4.9. Remove the four screws holding the handle bar
brackets in place using a T-27 Torx bit.
CAUTION: There is a spring pushing on the axle
housing. Take care to prevent the transmission
and axle housing from flying out.
NOTE: Make a note of which spacer goes
where. They are not interchangeable.
4.10. Place Transmission and chain case on a bench.
See Figure 4.10.
Figure 4.5
Remove the wing nuts and clips
Figure 4.6
Remove this bolt
Figure 4.8
Remove nut and hair pin clip
Figure 4.10