Cub Cadet CC 500 BAT - Manual (Page 30)

REPAIR PROCEDURES
26
6. Remove the four mounting screws. See Figure
3.13.
7. Install the motor by following the above steps in
reverse order.
8. Test run the mower before returning it to service.
Motor mount
To replace the motor mount:
1. Remove the safety key.
2. Remove the motor by following the steps
described in the previous section of this manual.
3. Remove the three mounting screws using T-40
torx driver. See Figure 3.14.
4. Remove the motor mount from the deck of the
mower.
5. Install the motor mount by following the above
steps in reverse order.
NOTE: tighten the motor mount screws to a
torque of 170-200 in-lbs (19 - 22.5 Nm).
6. Test run the mower before returning to service.
Figure 3.13
Mounting screws
Figure 3.14
Mounting screws